Extensive Range

GPIB- RS-485- RS-232 -USB-LAN Interfaces

ITS5300 Battery Charge&Discharge Test System

I Tech Auto Test Systems

Automatic Testing System - Customise - High Power
Power automatic testing system
Battery charge and discharge testing system
Automotive wiring box testing systems
Burn-in testing systems etc.

ITS5300 Battery ITS9500 Power Supply Test NEW

SystemCharge&Discharge Test System

 

Back to Itech Home


Talk to our MasTec's Sales Engineer

ITS9500 Power Supply Auto Test System
Programmable Instruments for Test

Professional Manufacturer

 
ITECH Electronics launches the NEW Energy-regenerative DC Electronic load.
IT8300 Series Energy-regenerative DC Electronic Load, it not only can simulate various load characteristics, but also can feed power back to grid without pollution. IT8300 series unique energy-regenerative function can convert the absorbed DC power into AC power and feed it back to local grid. This eliminates the usual heat dissipation to a minimum and saves energy costs, adapts requirements of global energy-saving and emission reduction at the same time. >>
Know more
 
Ultra high power regeneration efficiency up to about 95%
IT8300 series energy-regenerative DC electronic load is different from other conventional consumed loads, energy-regenerative function is the most important feature of IT8300 series. It can regenerate power to grid and provides low heat dissipation, which will be converted with an efficiency of approximately 95%. This way of energy regeneration helps to lower energy costs and avoids expensive cooling systems, and also reduces the noise.
IT8300 Series Energy-regenerative DC Electronic Load 
 
High Power Density Design
Conventional electronic loads are not only with high energy consumption, its own size and weight is also very large. Energy consumption electronic load with 10KW load is at least 12U, not only difficult to transport, the higher the cost. IT8300 series energy-regenerative DC electronic load adopts high power density design, e.g. for 3 U size, it can absorb power up to 10.5 kW. Compared to traditional electronic loads, the size for IT8300 series will be able to decrease by 76.9% under the same output power.

 
Applications
Discharge testing for different types of batteries (lead, lithium, power and energy storage batteries)
The virtual load test of natural energy (solar cell array, wind power generation)
Aging life testing for AC/DC, DC/DC converters
Aging testing for motor, fuse and relay under automobile high voltage (e.g., 36 v, 42 v) and small motor testing
Security testing for mechanical systems with large capacity battery (e.g. agv, health care electric chair)
Testing for large DC power supply, e.g. ground power test
Evaluation testing for fuel cells and stacks
Detection and aging for power electronic equipments

   
© MasTec Ltd 1997- 2019